Message Board
Message 5 of 5
Posted by member Steve Hogwood on Tuesday 17 March 2020
Hi Simon, got that will give it a go.
Thank you very much.
Steve.
Add your comment
Message 4 of 5
Posted by member Simon Papendick on Tuesday 17 March 2020
Hi Steve,
The lines have a small bowline in one end and the you tie off the line once you have tensioned up the line and half hitch the end of the line.
Regards
Simon
Add your comment | ^Top
Message 3 of 5
Posted by member Steve Hogwood on Monday 16 March 2020
Hi Simon,
the knots I am referring to would be the the three each side of the bow as opposed to the tensioning knots each side on the stern.
Cheers
Steve.
Add your comment | ^Top
Message 2 of 5
Posted by member Simon Papendick on Monday 16 March 2020
Hi Steve,
To which knot are you asking about?
Regards
Simon Papendick
P.S. Just fitted a pilot rope fender this morning
Add your comment | ^Top
Message 1 of 5
Posted by member Steve Hogwood on Sunday 15 March 2020
My query is what is the knot that is used to hold the fender rope in position ?
I have searched the message board and found a few bits and pieces but no mention of the knot used.
Maria gave me a clue where pliers are used in her article on replacing a rope Fender ,the nearest knot I reckon is the lorry drivers hitch!
Any ideas folks ?
Steve.
(Felix)
Add your comment | ^Top
You must be logged in to post to the Hardy Motor Boat Owners Club message board.
Click here to login in. If you’re not yet a HOC member then why not
join us today?